Repair, replace or redesign?

N.B.

This information is provided for general guidance only and is not a substitute for the manufacturer’s instructions, a site-specific risk assessment, applicable UK requirements or advice from a competent hydraulic professional. Hydraulic systems can contain high pressure and stored energy and may cause serious injury or death if incorrectly selected, assembled, installed, inspected or maintained. Never work on a pressurised system. Isolate, lock out and depressurise equipment before work, and use correctly specified, compatible components and approved assembly and testing procedures. If in doubt, stop work and seek competent professional advice. To the fullest extent permitted by law, Ardel OEM Limited accepts no responsibility for reliance on this information, subject to any liability that cannot lawfully be excluded or limited.

Safety first

Before inspecting, removing or replacing an assembly:

  • Shut down and isolate the equipment.
  • Lock out the power source.
  • Release hydraulic and accumulator pressure.
  • Place moving parts and loads in a safe position.
  • Never look for a hydraulic leak with your hand; use suitable paper, card or another safe method.
  • Treat a hose that has injected fluid into skin as a medical emergency.

Manufacturer guidance recommends regular inspection, with a common baseline of every 400–600 operating hours or every three months for mobile equipment, and every three months for stationary equipment—whichever is more frequent. The equipment and hose manufacturer’s instructions take priority.

SITUATIONRECOMMENDED ACTIONREASON
Loose or leaking connection, but hose and end fittings are undamaged.Repair or correct the connection.The cause may be incorrect torque, a damaged seal, or misalignment.
Worn hose clamp, guard, or support.Repair the installation.Poor hose restraint can lead to vibration, abrasion, and excessive movement reducing the life of the hose.
Hose cover lightly marked but the hose reinforcement is not exposed.Monitor, protect, or reroute.The damage may be superficial but the cause must be eradicated.
Exposed hose reinforcement, hose end fittings loose, deep abrasion or cuts to hose cover, or severe crushing.Replace hose assembly immediately.Structural integrity will have been compromised.
Leak through hose cover or end fitting, blistering, cracking, or charring of hose cover.Replace hose assembly immediately.These indicate severe deterioration, chemical attack, heat damage or internal failure.
Damaged, leaking or corroded end fittings.Replace hose assembly immediately.A hose fitting in poor condition can lead to a catastrophic failure, and potential danger.
Repeated hose failure in the same location and function.Check to hose specification is up to the job, redesign the routing and/or introduce more hose protection, clamping or support.Replacing the hose alone will not remove the root cause of the failures.
The hose in use is obsolete or unavailable.Identify a viable alternative hose specification and use this for a new hose assembly.The replacement must meet pressure, temperature, fluid, movement and connection requirements.
The age of a hose is unknown and the consequences of failure are serious.Replace hose assembly immediately.Do not wait for an age related failure in a high-risk application.